Every air conditioner makes some noise. A compressor humming, a fan turning, air moving through a vent. The sounds worth paying attention to are the ones that are new, that get louder over time, or that do not match anything the unit has done before. On their own, sounds do not tell you exactly what is wrong, but they narrow the list a long way, and they often tell you how urgent the problem is.
This guide groups the sounds people describe to us most often and explains what is usually behind each one. It is not a substitute for a technician looking at the unit, but it should help you describe the problem clearly and decide whether it can wait for a booked visit or needs attention sooner.
What a healthy AC normally sounds like
A working split unit makes a low, steady hum from the compressor, a soft whoosh of air from the indoor fan, and a quiet click or two when it switches on and off as the thermostat calls for cooling. The outdoor unit's fan makes a gentle whirr. None of this is loud enough to carry a conversation over, and it does not change in character while the unit runs. If what you are hearing is new, louder than before, or comes and goes oddly, treat it as worth investigating.
Clicking
A single click at start-up and shut-down is normal. It is usually a relay or contactor switching the compressor or fan on and off. Repeated clicking that does not lead to the unit starting is different. That often points to a contactor or capacitor that is struggling to hold the circuit closed, or a control board sending signals the compressor is not responding to properly. If the unit clicks several times and then runs, or clicks and never starts, it needs a technician before it is run again, since repeated failed starts put extra strain on the compressor.
Buzzing or humming that is louder than usual
A low hum is normal for the compressor. A buzz that is noticeably louder, or that has appeared where there was only a quiet hum before, often comes from a loose panel vibrating, a part that has worked itself loose inside the unit, or an electrical component such as a contactor or capacitor that is wearing out. Outdoors, a buzzing fan motor can also mean a bearing starting to fail. None of these are emergencies by themselves, but they tend to get worse rather than better, so it is worth booking a check before the noise turns into a breakdown.
Hissing or whistling
A soft hiss right after the unit starts or stops can be refrigerant equalising pressure inside the pipes, and that is usually nothing to worry about. A continuous hiss or a sharper whistling sound, especially near the indoor unit or along the copper pipes, can mean refrigerant escaping from a leak, which will also show up as weaker cooling and possibly ice on the pipe over time. A whistling sound from a vent, rather than from the unit itself, often just means the opening is partly blocked and air is being forced through a narrow gap.
Bubbling or gurgling
This sound usually comes from one of two places: refrigerant moving awkwardly through the pipes when the charge is low, or water and air moving through a partly blocked drain line. If you also notice weak cooling or ice on a pipe, think refrigerant. If you notice water pooling near the indoor unit or a musty smell, think drainage. Either way, it is a sign something needs attention rather than something to leave and see.
Rattling
Rattling is often the easiest sound to explain and sometimes the easiest to fix. Loose screws on a panel, a grille that has worked free, or debris such as a leaf, a small stone or a stray cable tie caught in the outdoor fan can all cause a rattle. Check that nothing is stacked against the outdoor unit and that its cover, if it has one, is seated properly. If the rattle is coming from inside the indoor unit, or you cannot see an obvious loose panel, leave it for a technician rather than opening the casing yourself.
Grinding or screeching
This is one of the more serious sounds on this list. Grinding or screeching, particularly from the outdoor unit, usually means a fan motor bearing is worn out and metal parts are rubbing against each other that should not be. A motor in this state can fail completely without much warning, sometimes damaging nearby parts when it does. If you hear grinding or screeching, switch the unit off and have it looked at rather than waiting for it to get worse.
Banging or thumping
A loud bang, especially a single one followed by the unit stopping, can point to a part breaking loose inside the compressor or a serious electrical fault. Repeated banging or thumping while the unit runs is often a sign of something unbalanced or loose in the blower wheel or fan assembly, sometimes caused by a build-up of dust and debris that has thrown it off balance. Either way, this is not a noise to keep running through. Switch the unit off and arrange a visit.
Noise from ducted and fan coil systems
Ducted systems and chilled-water fan coil units, common in apartment towers, hide most of their moving parts above the ceiling, so a new noise there can be harder to place than with a split unit you can see from the room. A dripping or trickling sound after the system has been running for a while is usually condensate moving through the drain line, and is only a concern if it is louder or more constant than before, which can point to a drain starting to back up. A rhythmic thumping from above the ceiling, in time with the fan, often means the blower wheel has become unbalanced, sometimes from a build-up of dust, and is worth having checked before it wears the motor further. Because these units are out of sight, it is easy to let a noise run for weeks before anyone notices, so it is worth asking whoever maintains the system to listen at the grille occasionally rather than only when something clearly fails.
Why a small noise tends to get worse, not better
Almost none of the sounds on this list improve on their own. A loose panel vibrates a little more each time the unit cycles. A worn bearing wears a little further every hour the fan turns. A refrigerant leak that is hissing faintly today will have lost more gas by next month than it has today, since the leak does not heal itself. This is the main reason it is worth paying attention to a noise early, even one that does not obviously affect how the unit cools: by the time a noise is loud enough to be undeniable, the part behind it has often been wearing for a long time already.
When to switch the unit off and not wait
Most unusual sounds can wait for a scheduled visit, but a few mean the unit should be switched off at the isolator or breaker straight away and left off until it has been checked:
- Grinding, screeching or banging, especially if it gets louder while you listen
- A hissing sound that is continuous and comes from the unit or pipes rather than a vent
- Any noise paired with a burning smell, smoke or sparks
- A noise that appears at the same time the breaker trips
- A noise paired with water appearing where it has not before
Describing the sound when you call
A technician who knows roughly what to expect can often diagnose faster once they arrive. When you call, try to say whether the sound is from the indoor unit, the outdoor unit, or both, whether it happens at start-up, constantly, or only sometimes, and whether it has changed or got worse over the last few days. If you can safely record a short video on your phone from a distance, without opening any panels or standing close to the outdoor unit, that can help too.
Noise on its own rarely tells the whole story, but it is almost never worth ignoring for long. A sound that was easy to fix a week ago, such as a loose panel or a rattle from debris, can turn into a failed motor or a damaged compressor if the underlying cause is left to run.